Skip to content

AQL and ISO 2859-1: how acceptance sampling works

Inspecting every piece of a lot is expensive and often impossible. Acceptance sampling sets how many pieces to inspect and how many defects to accept, with one rule every inspector applies the same way.

What AQL is

AQL, the Acceptable Quality Limit, is the worst average quality you accept from the supplier's process, as percent defective or defects per hundred units. It is the term used by ISO 2859-1 and ANSI/ASQ Z1.4. The Brazilian standard NBR 5426 calls it NQA and uses the same tables.

An AQL of 2.5 doesn't guarantee that an accepted lot has at most 2.5% defects. It is the starting point for choosing the plan: the lower the AQL, the stricter the acceptance criterion.

From lot size to sample

The plan comes from two tables. In the first, the lot size and the inspection level give a code letter. In the second, the letter gives the sample size and, for each AQL, the acceptance number (Ac) and the rejection number (Re).

Example: a lot of 200 pieces, level II, normal inspection. The letter is G and the sample is 32 pieces. With AQL 2.5 for major defects, the lot is accepted with up to 2 defects (Ac 2) and rejected from 3 (Re 3). With AQL 4.0 for minor defects, Ac 3 and Re 4.

When the table shows an arrow instead of Ac and Re, use the first plan in the arrow's direction, with its sample. If the sample is equal to or larger than the lot, inspect the whole lot.

Inspection levels

The level sets the sample size for the same lot. The higher the level, the larger the sample and the lower the risk of accepting a bad lot.

  • Level II: the default, used unless something else is specified.
  • Level I: smaller samples, when the track record allows less rigor.
  • Level III: larger samples, for higher-risk items.
  • Special levels S1 to S4: small samples, for expensive or destructive tests.

Normal, tightened and reduced inspection

Inspection starts at normal. The standard switches to tightened when lots start being rejected (2 out of 5 consecutive lots, for example) and back to normal after 5 consecutive lots are accepted under tightened.

Reduced inspection takes smaller samples and only applies when production is steady and the acceptance record meets the standard's conditions.

One AQL per defect class

Critical, major and minor defects have different criteria. In consumer goods, AQL 2.5 for major and 4.0 for minor defects is common, with no critical defects accepted. Each class is counted separately, and the lot is rejected when any class reaches its rejection number.

See Traqer in your inspection process.

In 30 minutes, we show you how to set up a checklist template and a sampling plan for one of your products.

Book your free demo

30 min · no commitment · reply within 1 business day